An investigation of the effects of cutting parameters and graphite reinforcement on quality characteristics during the drilling of Al/10B4C composites
[ X ]
Tarih
2017
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Elsevier Sci Ltd
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
This study investigated the effects of cutting parameters on the quality characteristics of thrust force (Ft), surface roughness (Ra), dimensional accuracy (Da) and burr height (Bh) during the drilling of Al/10B(4)C and Al/10B(4)C/5Gr composites. Machinability experiments were carried out with uncoated carbide twist drills at three different cutting speeds (18, 25 and 35 m/min) and three different feed rates (0.08, 0.112 and 0.16 mm/rev) under dry cutting conditions. The percent contribution of the cutting/drilling parameters/variables to the quality characteristics was determined using analysis of variance (ANOVA), and predictive linear equations were developed for the estimation of all the quality characteristics. As a result of the experimental study, it was determined that during the drilling of the composites, the 5% graphite reinforcement of Al/10B(4)C/5Gr decreased the thrust force and the burr height, improved the surface quality and brought the composite closer to its ideal diameter value. (C) 2016 Published by Elsevier Ltd.
Açıklama
Anahtar Kelimeler
MMCs, Drilling, Thrust force, Surface roughness, Dimensional accuracy, Burr height
Kaynak
Measurement
WoS Q Değeri
Q2
Scopus Q Değeri
Q1
Cilt
95
