Evaluation of Machining Characteristics and Tool Wear During Drilling of Carbon/Aluminium Laminated

Basit Öğe Kaydı
dc.authoridMotorcu, Ali Rıza/0000-0002-9129-8935
dc.authoridKesarwani, Shivi/0000-0002-5630-1254
dc.contributor.authorMotorcu, Ali Rıza
dc.contributor.authorEkici, Ergun
dc.contributor.authorKesarwani, Shivi
dc.contributor.authorVerma, Rajesh Kumar
dc.date.accessioned2025-01-27T20:29:51Z
dc.date.available2025-01-27T20:29:51Z
dc.date.issued2024
dc.departmentÇanakkale Onsekiz Mart Üniversitesi
dc.description.abstractIn the past few decades, fibre metal laminate (FML) machining has been facing critical challenges in quality control and tool wear monitoring due to the material's intrinsic heterogeneity and abrasiveness. Different drill tools have been used to investigate the effect of process parameters on machining performances. Composite holes and tool wear was studied for drilling forces and surface roughness. An emphasis was made on examining the tool morphologies and wear processes that influence the drilling of CARALL composites. The drilling responses obtained from both the drill bits were optimized using a decision-making approach viz; Combined Compromise Solution Analysis (CoCoSo). The SEM investigation of the machined samples was used to examine the hole quality and surface finish. A lower point angle drill with a longer chip flute length produced the best results for drilling CARALL composites up to a specific point with minimum flank wear and chip adhesion.
dc.description.sponsorshipCanakkale Onsekiz Mart University Scientific Research Projects Unit [FBA-2019-3170]
dc.description.sponsorshipThe authors would like to sincerely thank the Canakkale Onsekiz Mart University Scientific Research Projects Unit for supporting the project (No.FBA-2019-3170) .
dc.identifier.doi10.5937/fme2403343M
dc.identifier.endpage359
dc.identifier.issn1451-2092
dc.identifier.issn2406-128X
dc.identifier.issue3
dc.identifier.scopus2-s2.0-85199093007
dc.identifier.scopusqualityQ2
dc.identifier.startpage343
dc.identifier.urihttps://doi.org/10.5937/fme2403343M
dc.identifier.urihttps://hdl.handle.net/20.500.12428/23053
dc.identifier.volume52
dc.identifier.wosWOS:001270109700001
dc.identifier.wosqualityN/A
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.language.isoen
dc.publisherUniv Belgrade, Fac Mechanical Engineering
dc.relation.ispartofFme Transactions
dc.relation.publicationcategoryinfo:eu-repo/semantics/openAccess
dc.rightsinfo:eu-repo/semantics/openAccess
dc.snmzKA_WoS_20250125
dc.subjectCARALL
dc.subjectdrilling
dc.subjectcutting force
dc.subjecttorque
dc.subjectsurface roughness
dc.subjecttool wear
dc.subjectCoCoSo
dc.titleEvaluation of Machining Characteristics and Tool Wear During Drilling of Carbon/Aluminium Laminated
dc.title.alternative??????? ?????????????? ?????? ? ?????? ????? ????? ?????? ????????/??????????-??????????
dc.typeArticle

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu