Yazar "Aslan, Yasemin" seçeneğine göre listele

Listeleniyor 1 - 2 / 2
  • [ X ]
    Öğe
    Crustal Structure of Turkey from Aeromagnetic, Gravity and Deep Seismic Reflection Data
    (Springer, 2012) Ates, Abdullah; Bilim, Funda; Buyuksarac, Aydin; Aydemir, Attila; Bektas, Ozcan; Aslan, Yasemin
    In this paper, aeromagnetic and gravity anomalies obtained from the General Directorate of Mineral Research and Exploration were subjected to upward continuation to 3 km from the ground surface to suppress shallow effects and to expose only regional, deep sources. Then, a reduction to pole (RTP) map of aeromagnetic anomalies was produced from the 3 km upward continued data. A sinuous boundary to the south of Turkey is observed in the RTP map that may indicate the suture zone between the Anatolides and African/Arabian Plates in the closure time of the Tethys Ocean. The sinuous boundary can be correlated with the recent palaeo-tectonic maps. The southern part of the sinuous boundary is quite different and less magnetic in comparison with the northern block. In addition, maxspots maps of the aeromagnetic and gravity anomalies were produced to find out and enhance the boundaries of tectonic units. Crustal thickness, recently calculated and mapped for the western Turkey, is also extended to the whole of Turkey, and the crustal thicknesses are correlated with the previous seismological findings and deep seismic sections. The average crustal thickness calculations using the gravity data are about 28 km along the coastal regions and increase up to 42 km through the Iranian border in the east of Turkey. Density and susceptibility values used as parameters for construction of two-dimensional (2D) gravity and magnetic models were compiled in a table from different localities of Turkey. 2D models indicate that all of the anomalous masses are located in the upper crust, and this could be well correlated with the earthquakes which occurred at shallow depths.
  • [ X ]
    Öğe
    Geophysical investigation and hydrocarbon potential of Cankiri-Corum Basin, Turkey
    (Elsevier Science Bv, 2013) Aslan, Yasemin; Buyuksarac, Aydin; Erik, Nazan Yalcin; Aydemir, Attila; Ates, Abdullah
    The Cankiri-Corum Basin is one of the larger, onshore sedimentary basins in central Turkey. In this paper, the integration of geophysical data and geological findings in the Cankiri-Corum Basin was performed and they both present a complex basin structure. In the frame of geophysical study, two-dimensional (20) models were constructed using gravity and magnetic anomalies. Seismic sections were interpreted and correlated with the 2D models using the borehole data as control. Basement depth, basin geometry and sources for magnetic anomalies along the 20 model profiles were determined in integration of seismic, gravity, aeromagnetic and borehole data. Seismic section CC-L-1 is correlated with the Topuzsaray-1 well. Tuffs and volcanic units penetrated in this well might be correlated across a reverse fault close to the borehole. Seismic sections, CC-L-2 and CC-L-3, are consistent with the gravity models at the deeper parts of the sections. On the other hand, there are inconsistencies in the shallow sections with the gravity models due to unexpected velocity variations in both the horizontal and vertical directions. The average depth of basement was found to be about 5 km by means of gravity modelling, which was correlated with the seismic sections. Magnetic anomalies are represented by intense values in the NW portion of the study area, but they indicate very low intensities in the middle of the map. A reverse magnetised body to the north of the study area was modelled in 2D along a profile and it was interpreted that this body might be an ophiolitic remnant. Polarities of many anomalies to the south and northeast of the region indicate remanent magnetisation. Alignment of the polarities extends in the northwest direction, indicating that the region rotated in the anticlockwise direction. Because there is around a 5 km sedimentary basin fill in the study area, it may exhibit hydrocarbon potential and the Yesilcat oil seep evidences this potential. Surface samples were collected to examine source rock potential and to correlate with the Yesilcat seep by analysing the organic geochemical properties. In this study, 72 samples were collected from different formations and it was found that the Yoncali Formation displays better source rock potential than the other formations studied. (C) 2013 Elsevier B.V. All rights reserved.